Busch&Muller Lumotec IQ Eyc 50 Lux

Busch&Muller Lumotec IQ Eyc 50 Lux

57.00
  • input voltage between 6 and 42V DC
  • The new Lumotec IQ2 Eyc E-Bike light from Busch & Muller incorporates all of the best features of the dynamo model but is designed to work with most E-Bike systems currently on the market. It can be connected to all DC power sources supplying between 6 and 42V DC. The 50 lux output with Close Range Light creates a far reaching, wide and evenly lit beam pattern ideal for faster moving E-Bikes. The Eyc is switchless. This means that it is always turned on or is switchable via the E-Bike console

    The Eyc E has an inbuilt converter that generates a 6V DC output designed to work with specially designed E-Bike rear lights from B&M. It is possible to run standard rear dynamo lights with the Eyc E however please note that the stand light function will remain on after the E-Bike system is turned off

    The Eyc can be used with Bosch & STEPS systems. Please note that on some of these systems the rear lights will be connected via cables directly from the battery. In these cases the rear wires/spades on the Eyc must be isolated

    The Eyc can be used in conjunction with the Yamaha systems which produce 500 mA. However, it is not always possible to run a rear light as well due to the lower power output of the Yamaha system

    For use with E-Bikes only
  • Can be connected to all DC power sources supplying between 6 and 42V DC, i.e. most E-Bike systems currently available
  • 50 lux output
  • Switchless - controlled via the E-Bike console
  • Incorporates a converter that generates a 6V DC output intended to supply the E-Bike rear lights
  • Regular rear dynamo lights can be used with this front E-Bike light
  • Supplied with a clip on reflector
  • Supplied with a twin cable which is hard wired into the light ready to be attached to the battery
  • Can be used with all Bosch & STEPS systems
  • Cannot be dynamo driven

<

  • Please note the following recommendations from Busch & Muller if you are planning to install your own E-Bike lighting system: 




  •  
  •  
  • Establish and/or measure the voltage on the cables or connecting point intended for the connection. Make sure this is within the parameters of the light specification
  • Establish and/or measure the polarity of the above mentioned connection and make sure to connect respectively to the correct pole using the instructions and/or the + / - signs on the light
  • If you are not able to establish either of the above, or are not sure then please refer to your local electric bike specialist to install the lights for you 
Add To Cart