Supernova E3 PURE3 Multimount

Supernova E3 PURE3 Multimount

from 124.00
  • The E3 PURE 3 has three amazing design features: it's sleek, bright and light weight. It's one of the smallest and brightest dynamo lights with an aluminium body that is approved for use under the strict German Road standards. It runs non stop which means that you hardly have to think about it - unless of course you exceed its exceed the LEDs expected lifespan of over one hundred years*! * Ie 50,000 hours approximately (if used normally on a day to day basis)

    The Terraflux 2 lens is unique and allows the E3 PURE3 to produce lights that function both at night and during the day as daytime running lights. Supernova have eliminated unnecessary electronics and additional LEDs in order to add a minimalistic light to their excellent range of dynamo lights

Specifications

  • Measured lumen value: 205 lumens
  • Input voltage: 6 V AC Dynamo
  • Standlight: 5 minutes
  • Lens type: Terraflux 2
  • Illuminant: Power CREE LED
  • Length x diameter: 49 x 41 mm
  • Material: 6061 Aluminium
  • Weight: 90 g
  • Warranty: 5 years

Lens Information

  • TERRAFLUX2 - Supernovas Best Lens To Date 

    After many years of development and improvements, the new Supernova TERRAFLUX2 lens now surpasses even the high demands of German road regulations. The TERRAFLUX2 technology is capable of guiding over 90% of the light beam onto the ground with greatest efficiency. This means that a considerably greater portion of the light can be used to illuminate the road ahead than with standard lenses. By optimizing the production parameters, Supernova have achieved an excellent homogeneous beam shape with an outstanding, far reaching light that has an unparalleled side illumination as well. The Terraflux2 lens is used in several Supernova lights. Its brilliance is an important part of the quality that makes Supernova lights special.

    The Complex Production Method Explained 

    The Supernova TERRAFLUX2 lenses are produced with an additional complex process of added holding pressure after the commonly employed injection of the molten PMMA material with up to 6500 psi. A die integrated into the tool exerts a high and uniform pressure directly onto the light exit surface of the lens while the molten mass is still liquid or while the temperature is still above the yield point. This allows Supernova to achieve a very homogeneous stress distribution inside the component, which gives the TERRAFLUX2 lens its excellent quality
finish:
Quantity:
Add To Cart